Based on the tried-and-tested HANGLER welded construction using high-quality steel with forward-tapering welded longitudinal beams. Frame neck with double center web. Z-profile crossbeams punched through the longitudinal beam with welded special side frame. Replaceable 2" kingpin, beveled forward with a grinding plate, made of high-quality steel sheet. 18 pairs of lashing rings embedded in the outer frame, each with a capacity of 2.5 tons, 8 pairs of folding lashing rings embedded in the outer frame, each with a capacity of 5 tons, 24 tons. 2-speed support winch, single-side operation, with straight lower part, 2 support wedges with holder, aluminum side impact protection, plastic fenders in front of and behind each axle, with anti-spray flaps behind each axle, underrun protection at the rear, spray flaps at the rear over the entire width, coil trough approximately 8,000 mm long with cover, approximately 40 mm, divided by angled loading beams. Stanchion sockets and supports suitable for FR 80/80/4, completely hot-dip galvanized. Plug-in stanchions 80/80 including lower reinforcement, hydraulic angled loading device with 4 crossbeams: hydraulic supply via tractor unit using a 2-line pump system (supply and return) with a 2-way quick-release coupling. Angled loading beams with integrated extendable sections that can be locked in height. Hydraulic cylinders multi-stage, each beam with a universal joint suspension. Including supports - adjustable - with pin securing. Cylinder passages with strip brush seals on both sides, to protect against weathering and cleaning of the piston rods. 5-way control block for operating the angled loading device as well as for the folding device. Sliding tarpaulin, including tarpaulin rail cover, 1 set of coil floor holder with height-adjustable support bolts for various coil floor diameters, including storage. 1 piece of impact protection for angled plate - for securing at the front, BPW or SAF disc brake axles, at the manufacturer's choice, offset axle spacing 1310/1450 mm, air suspension, 2-line compressed air brake system, aluminum compressed air tank, spring brake parking brake, axle load recognition via EBS-CAN bus signal, for display on the display in the cab, the truck must be correspondingly pre-equipped, "TPMS" tire pressure monitoring system according to ECE R 141, display via display in the tractor unit, via EBS, 435/50 R 19.5", manufacturer's choice, 24 volts, multi-chamber lights, yellow LED lighting on the side, yellow LED lighting on the side coupled with the turn signal "flashing side marker lights", 2 x 7-pole and 1 x 15-pole fail-safe sockets at the front, additional 7-pole socket (according to ISO 1724) in the underrun protection at the rear, pair of warning signs double LED illuminated and extendable to 3,000 mm, removable with a plug, LED beacon with holder, switched via parking lights, sieve-printed panels approximately 30 mm thick, flush-mounted with the side frame! Front wall made of aluminum hollow profiles, fixed height approximately 2,400 mm, with wooden slats above it. Inside reinforced with 3 mm aluminum sheet, approximately 630 mm high from the floor as a baseboard. 2 front VOLUMEN corner posts, permanently mounted, approximately 2,400 mm high, 3 pairs of Kinnegrip center posts, approximately 600 mm high with Kinnetop at approximately 2,000 mm, 1 pair of plug-in rear corner posts including reinforcement inside up to the 1st slat row, aluminum hollow profile, approximately 600 mm
Lodpfx Asi Riw Hecpjrn
Oglas je automatski preveden. Moguće su pogreške u prijevodu.
